Account
Inquiry
Actually delivers consistent sterilization across each cycle because the three vacuum pulses pull air out before steam even enters—chamber reaches 0.22 MPa and holds 134°C ±1°C. We've run wrapped surgical packs through the 35DV model and the internal load stays bone dry afterward, moisture reads under 0.2% with the drying function engaged. Temperature adjustment goes from 55°C up to 134°C, timer covers 0 to 99 minutes, so you're covered for liquids on the low end and hard goods up top.
Choose between five chamber volumes—12L, 18L, 24L, 35DV, or 50DV depending on what your lab actually processes daily. The LCD with touch keys isn't just for show; it's pretty straightforward to set a cycle without flipping through a manual. An optional built-in mini printer tags along if you need a paper trail for compliance, but most buyers skip it unless inspectors insist (usual deal is they want printouts for each run).
CE cerification sits on the nameplate, but what it doesn't do is replace a lab-grade gravity sterilizer for porous loads in high-throughput clinics—it's better suited for smaller hospital floors or dental practices. Handpieces, hollow instruments, glassware, wrapped trays all run fine. We've seen some max out the 50L with mixed loads of surgical tools and tubing, and it still hits sterilization temp within about 12 minutes give or take.
Builder's used a lot of cheaper autoclaves from the same factories that look similar on paper, but the stainless chamber on this one holds up longer after hundreds of cycles—no pitting or scaling after six months at 134°C. Overload protection and pressrue lock system kick in hard if something's off; if a seal fails mid-cycle, the alarm trips before you even notice. We validate every unit with a test printout before shipping, not a simple pass on paper.
MOQ runs at 2 units for the custom voltage options, but the standard 220V models ship within 20 days or so form stock. Use a 0.22 micron vent filter on the exhaust line if you're processing biohazard waste—spec sheets don't mention it but local SOPs often do. Packaging is double-walled carton with foam inserts; the 50L model weighs about 85 kg so a pallet is the way to go. Costs land roughly 15-20% more than a single-vacuum unit, but you'll spend less on cycle time and fewer rejected loads per week.
We have a minimum order quantity of 10 units for the 12L model, but we can discuss lower quantities for first-time buyers or sample orders.
Lead time is typically 15-20 working days for standard models like the 50L, depending on stock levels and order volume.
Yes, every unit from the 12L to the 50L comes with CE certification, so you're covered for medical use in regulated markets.
Absolutely, we can make the built-in mini printer a standard feature for larger orders—just let us know your quantity when ordering.
Store it in a dry, clean environment between 5-40°C to avoid moisture damage to the stainless steel chamber and electronic components.
