Account
Inquiry
In messy trauma cases where every second and every millimeter counts, getting a clean pilot hole fast can be difference between a solid fixation and a compromised reduction—so that's teh real problem this rig is built to handle. 2. Basically, it lets you drill over a guide wire thanks to the 4.0mm cannulation, which is something you don't always get in a handpiece this light (it's only 0.4kg). 3. Variable speed form 0 to 1000 RPM gives you fine control for cortical bone versus softer cancellous, and the axial runout is held to ≤0.05mm so you're not wobbling the wire around. 4. It runs off a Ni-MH battery that's good for about 30 minutes per charge, and the charger cycles back up in 3 hours. 5. Most buyers go with the 6mm chuck version for standerd K-wires, but you can also get the 8mm chuck if your protocol uses larger bits. 6. We usually have stock on these, but confirm lead time if you need a specific sterilization cycle or custom labeling—the autoclave temp is 135°C on the spec sheet.
Our standard MOQ is 50 units per model, but we can negotiate smaller trial orders for first-time buyers. Just reach out to our sales team with your expected volume.
Lead time is usually 25-35 working days after order confirmation and deposit. Custom branding or packaging may add a few extra days, so we'll confirm once your specs are finalized.
Absolutely. We’ll include CE and ISO certificates with your shipment, and we can share digital copies beforehand for your compliance review.
Yes, the entire handpiece is made from medical-grade stainless steel and can withstand autoclaving at 135°C. The battery and motor module should be removed before sterilization though.
The ND-2511 comes with either a 0.6-6mm or 0.6-8mm chuck. Both are quick-release and interchangeable, so you can swap them depending on your drill bit size needs.
