Account
Inquiry
We ordered the MD-1001 sagittal saw bone drill for orthopedic cases where you need that variable speed control from a dead stop up to 13000 rpm—the 130W motor handles cortical bone without stalling, and they claim ≤65 dB in the OR, which is quieter than most pneumatic options I've seen. It runs on a 14.4V Ni-MH battery pack, not lithium, so charging takes 2.5-3 hours, but the max sterilisation temp of 135°C means autoclaving is fine as long as your cycle doesn't exceed that.
Basically, this is for hospitals doing routine joint replacements or trauma repairs where the surgeon wants a single tool for both sawing and drilling, with that 0.6mm to 8mm chuck range covering most pin and screw sizes. It's not meant for high-torque reaming application—the 7500g/cm torque is decent but we're not using this for intramedullary nailing, and temperature rise stays ≤25°C under load, so it doesn't get too hot in your hand during longer cuts, anyway.
The diameter run-out is ≤0.5mm, which is acceptable for drilling pilot holes but not for precision implant seating without a guide—about what you'd expect form an integrated aluminium alloy housing at 1.5kg. CE and ISO13485 certs are in place, and we're asking for batch-specific COAs on delivery, though sometimes they send a generic one unless you specify at order; the retest policy covers HPLC purity checks if we question any batch.
Most buyers I've talked to go with the 110V or 220V charger depending on region—it ships with either, but confirm before ordering since lead time varies by voltage option, usually 20 days or so. The warranty is two years techncial support, not replacement parts, so we'll keep a spare unit on hand for critical cases. 5. Lead time is roughly 4-6 weeks from order, but they've been pretty consistent lately on that 30-day window—just confirm when you place it, and we'll request the 0.6mm-8mm chuck as standdard, though the 6mm version is more common if you're mostly doing 2.7mm screws.
Our MOQ for the MD-1001 is typically 50 units, but we can negotiate smaller trial orders for first-time buyers. Just reach out to our sales team with your requirements.
Yes, we include copies of CE and ISO13485 certifications with every order. We can also send them in advance for your quality team to review.
Absolutely, the MD-1001 has a variable speed trigger with a lock button, so you can set it anywhere from 0 to 13000 RPM and maintain that speed during surgery.
Each drill comes in a sealed medical-grade case with foam inserts to prevent damage. Lead time is 15-25 working days after order confirmation, depending on customization.
Yes, the drill chuck can be customized to 0.6mm-6mm or 0.6mm-8mm, and we can switch to Li-ion batteries if needed. Just let us know your specs before production.
