UL Certified 2468 Flat Wire with Tinned Copper Conductor - Bulk Order Discount

A technician's tightening a terminal screw on a flat ribbon cable inside a commerical espresso machine, and that wire has to lie perfectly flat against the contact or the whole brew cycle faults out — we've seen it happen.

UL VW-1 FT1 is the one that matters for internal wiring in metal enclosures, and this stuff passes it without any surface treatment tricks; the PVC just smothers itself out in under 15 seconds (we tested a scrap length once, just to see).

300V and 80°C cover about 90% of what we see in domestic appliances and small control panels, though if you're jamming it into a toaster oven near the heating element you'll want to step up to a higher temp rating — this isn't for that.

We usually stock the 22AWG and 20AWG in both 100m and 305m rolls, but the 16AWG flat profile is actually a bit harder to source, so allow 4 weeks or so for that one; the tinning is consistent and stripped ends don't fray like some budget imports.

Buyers who run continuous pull-through operations tend to prefer the 305m rolls because the drum changeover delay is basically eliminated, and the uniform insulation thickness means your automatic stripper settings don't drift midway through a batch.

32AWG is availble but honestly most folks find it finicky for anything beyond signal-level wiring in tight ribbon bundles — teh 24AWG to 18AWG range is where you'll get the best handling balance for appliance internal harnesses.