Account
Inquiry
So you're looking at wall-mounted air sterilizers for a hospital setting — honestly, that's where these things really shine, and we've been moving units like this for years now. It basically pulls air in at 100 cubic meters per hour and runs it through a plasma field combined with UV light, which is a pretty combo for knocking down airborne pathogens.
Most buyers go with this for operating rooms, isolation wards, or ICU corridors where you need consistent sterilization without taking up floor space. We've also had clinics and dental offices grab them for treatment rooms, though it's overkill for a small office — the 100m³ coverage is designed for larger spaces. What it does is maintain a constant low-level ozone residue under 0.02 mg/m³, so you don't get that sharp smell some older units leave behind.
LCD display and remote control make programming a breeze — there are six timer settings you can cycle through, which is handy for shift changes or overnight operation. Physicall dimensions are 1110mm wide by 175mm deep and 422mm tall, weighing in at about 33.3 kilos, so you'll want a solid wall anchor or bracket (usually included). Power draw stays under 80 watts, which is actually less than a standard light bulb, and the plasma generator is over 8000 hours — roughly a year of continuous use — before you'd need to think about replacement.
One thing buyers don't always ask but should: the sterilization field runs at 8000V while the dust accumulation field is at 4000V, and that dual-voltge setup means it catches particles while also zapping bacteria. We've seen test reports showing over 99.9% kill rate on Staphylococcus albicans and about 92% on natural bacteria in real-world conditions. Just keep in mind it's not meant for chemical fume removal or smoke — it's strictly biological and particulate control.
We usually have these in stock, but confirm lead time if you need more than 50 units or so — sometimes the MOQ kicks in and we batch ship. Anyway, the cerification covers medical device standard, so you're covered for hospital inspections without scrambling for paperwork.
Our MOQ for this model starts at 10 units per order. We can discuss smaller quantities for initial trial orders.
Standard lead time is around 15-20 working days after order confirmation and payment. Larger orders may need a bit more time.
It meets Medical Device Standards, and we can provide CE and ISO13485 documentation upon request. Let us know if you need specific certificates.
You can use the remote control to choose one of the 6 program-controlled timer settings. The LCD display makes it easy to switch between manual, timing, or temporary modes.
Store it in a clean, dry place at room temperature, away from direct sunlight and moisture. The package dimensions are 1150×260×492mm, so plan for adequate space.
