Account
Inquiry
We needed something that could handle the constant connect-disconnect cycles on the excavator's hydraulic lines without leaking or failing under 10,000 PSI, and the ball-locking mechanism with the sleeve lock is what sold me—it distributes the load evenly across multiple locking balls instead of concentrating stress on one point, so you don't get that gradual wear that kills cheaper couplings after a few hundred cycles.
Rated flow is 6 GPM at 22.7 LPM, which is tight for some larger hydraulic motors but fine for most hand tools and test stands we run, and the temperature range with NBR seals goes form -20°C to +120°C, though if you're working with phosphate esters you'll need different seals obviously. The positive shut-off valve uses a metal-to-metal stop with an elastomeric seal, so it actually seals better than the all-rubber designs we've tried—less blow-by when you break the connection under residual pressrue.
We usually have stock in 1/8" through 2" with BSPP and NPT threads, but check lead time on SAE or NPTF since those are special order (usually 2-4 weeks). Chrome plating on carbon steel gives decent corrosion resistance for outdoor railway maintenance work, but it's not suited for subsea or salt spray environments—you'd want stainless for that. Most buyers go with the 1/4" or 3/8" sizes for hand tools, anyway.
Compatibility is with Parker TC Series, which covers most of our fleet, and the locking sleeve mechanism prevents accidental disconnection when hose gets snagged on rebar or equiment—that's a concrete detail you don't think about until you've had a coupling pop off and spray hydraulic oil everywhere. The brass surface treatment isn't just cosmetic; it reduces galling on the threaded ends compared to bare steel, so we've had fewer seized connections on the older fittings.
For ordering, MOQ is usually 50 units or so for the standard sizes, but our company can do smaller lots if you're prototyping or replacing a single blown coupling—just confirm with the suppiler first. OEM customization is available on the thread end connections if you need something non-standard, though that pushes lead time out to about 20 days or so. We've got COAs on hand for every batch, and the HPLC data confirms consistent valve seating across.
Our LSQ-TC series is designed to be fully interchangeable with Parker’s TC series. They will mate directly with Parker TC socket and plug combinations, so you can swap them in without any adapter hassles.
MOQ depends on the size and thread type, but generally we can start from 100 pieces for standard sizes like 1/4" or 3/8". For custom threads or larger sizes, the MOQ might be a bit higher.
Absolutely—we can issue a material certificate and a pressure test report upon request. Just let us know what documentation your QA team needs, and we’ll include it with the shipment.
Yes, we offer SAE, NPTF, and other threads from 1/8" up to 2". For sizes over 1", just confirm the exact thread spec, and we’ll machine them to match.
Keep them in a dry, indoor environment with low humidity—ideally below 60% RH. The chrome-plated brass finish is pretty durable, but extended exposure to moisture or corrosive fumes can dull it, so avoid that.
