Account
Inquiry
We've been shiping these for a while now, and the 1000kn capacty handles pretty much anything you'd throw at it in heavy indutrial testing, though it's overkill for thin plastics or foams.
It's basically a hydraulic beast that does tension, compression, and bending on metals and composites, and the computer spits out Excel reports without you having to wrestle the data.
Stroke is 550mm for tensile and 450mm for compression, the 0.01-50mm/min speed range gives you fine control, and it takes round samples form Φ13 to Φ40mm or flat ones up to 30mm thick by 70mm wide—the 0.5 accuracy grade is tighter than most general-purpose rigs.
frame's high-strength steel, so it doesn't flex under load, and the emergency stop is right where you'd expect it; we usually keep stock, but confirm lead time if you're in a rush (20 days or so typically).
Most buyers go with the standdard AC220V power setup, but we've had some ask about 380V conversions, which our company can do if needed.
We typically require a minimum order of 1 unit for this model, but we can discuss larger quantities if you need multiple machines for different labs.
Lead time is usually 30-45 days after order confirmation, depending on current production load and customization requirements.
Yes, we supply a certificate of compliance showing the machine meets ASTM E8, EN 10002-1, and ISO 6892 standards. Third-party calibration certificates are available at an extra cost.
Absolutely, the speed range is 0.01-50mm/min and you can change it in real time through the PC software during the test without stopping the machine.
The machine is shipped in a reinforced wooden crate with foam padding. Store it indoors in a dry, dust-free area with temperatures between 10-40°C and avoid direct sunlight.
