Factory Direct 408 PCS Diode Lipolaser Equipment for Non-Invasive Fat Removal

You're looking at one of the more serious setups in non-invasive fat removal, with 408 individual diodes packed into those pads—basically a dual-wavelength system running 650nm and 980nm that targets fat cells through the membrane rupture theory, no surgery involved.

Each Mitsubishi ML101J27 diode fires in pulse mode form 130mW up to 350mW, and the total machine output hits 100VA, so you're getting enough energy to treat larger areas like the abdomen or thighs without needing to run it for hours. The control is an 8-inch TFT touch screen—pretty intuitive once you've used it a few times, but the first setup might take a minute. It's air cooled, weighs about 42 kilos, so you'll want a cart or a sturdy table.

For applicaion, we see most buyers targeting waist and abdomen first, then moving to buttocks and arms—it handles those well. That said, it's not great for very small, bony areas like knuckles or ankles; the pads are designed for broader coverage. You get 12 pads total, 10 large and 2 small, which gives you flexibility for different body contours.

Qualiy-wise, the diodes are from Mitsubishi, which is a solid source—we've had very few failures over the years. One thing buyers don't always think to ask: the operating temperature range is 10°C to 40°C, and humidity below 75% RH, so if your clinic gets humid in summer, you might need to check your air conditioning. Warranty runs 12 months, and we usually have replacement diodes in stock if needed.

On ordering, the MOQ is one unit, lead time about 20 days or so—we typically ship within that window, but confirm for your region since power requirement can be 220v or 110v depending on your setup. Packing size is 63cm by 47cm by 123cm, so plan for that. We've sold these for years, and most buyers go with the standard config rather than customizing pads.