Account
Inquiry
If your client needs a full-arch zirconia bridge done by tomorrow morning, this machine can rough it out in about 45 minutes with a 2.0mm bur at 45,000 RPM, then finish the margins with a 0.3mm bur at 25,000 RPM — teh 3μm repeatability means you won't need to remill any single unit.
We've got about 16 units in our warehouse right now, usually ships within 7 working days or so once the LC clears, but if you need just one for a lab trial our company can sometimes expedite the air freight (check lead time).
Most buyers actually go with the dry milling mode for wax and PMMA, since wet mode for ceramics needs the air pressrue set at exactly 5.5 bar or the coolant system won't atomize properly, and that's a detail the manual doesn't spell out.
The max bridge length of 3-4 units is fine for most single-visit cases, but honestly it's not suited for implants-supported full arches, that'll need a 5-axis model.
Packaing is a foam-lined crate, about 95kg total weight, so shipping costs roughly $300-400 air freight to most Asian ports, but we usually recommend sea freight for anything over 50 units.
The DDM-5A supports 0.3mm, 0.6mm, 1.0mm, and 2.0mm burs. You can use third-party burs as long as they match these shank diameters, but we recommend ours for best precision.
Our MOQ for the DDM-5A is 1 unit, so you can start with a single machine to test it in your lab before scaling up.
Yes, the DDM-5A is ISO and CE certified, and we include full certification documents with every shipment to support your quality compliance.
Yes, the DDM-5A supports both wet and dry milling. Switching modes just requires connecting or disconnecting the coolant line — it's straightforward and doesn't need extra kits.
Standard lead time is 7-10 business days after order confirmation, depending on stock. We'll confirm exact timing when you place the order.
