High Power S350 Hydraulic Sheet Pile Vibro Hammer for Excavators 18-25 Tons

Right now, we're sitting on decent stock of the S350, so shippng's usually within a week or so once you finalize the order—cold chain's not an issue since it's a standdard steel unit, just strapped on a pallet.

It's built with Parker motor and SKF bearings, which most guys prefer for reliability around the 360KN force it pushes at 3000RPM, and the hydraulic system runs at 32MPa with 320LPM flow, so it'll hit about 9 meters on pile length without struggling.

We've had a few buyers push it for 18 to 25-ton excavators, and the rubber damping blocks actually make a difference in operator comfort—those off-brand vibro hammers just don't absorb shock as well. But one thing, it's not really meant for heavy clay or rocky soils unless you keep the pile short, say 6 meters or so.

Or you can grab it with OEM customiaztion—we do the Q3550 Hardox450 as standard but can tweak the eccentric moment torque (36 N.M currently) if your flow demands vary; the open box structure helps avoid overheating, which is pretty much a must on longer shifts.

Anyway, it's CE and ISO certified, an 18-25 ton excavator driver usually matches best, and the MOQ is just one unit if you're testing waters—but confirm lead time if you're ordering more than three at once, as we sometimes have to batch orders for the cycle.

That warranty runs 12 months, and we've seen these hold up better than the Chinese-made H-Pe stickers long-term—though the dustproofing on teh rotary motor is a nice touch for coastal sites with blowing sand, but don't expect it to stay completely sealed after 200 hours or so without a clean.