High-Quality ABS Emergency Medical Trolley for Hospital Outpatient and Emergency Use

Look, I get it—you’ve been burned by trolleys that wobble after six months or drawers that jam when you’re in a rush, and that’s exactly why we put this one through the wringer before it leaves the factory; every unit gets a full load test at 150 kg, we check the drawer slides for smooth operation at least 50 cycles, and teh casters are spun on a test rig to make sure they don’t lock up under load.

The work surface is 512 by 433 mm of stainless steel with that 12 mm edge—it’s not just for show, it’s thick enough to take a dropped monitor without denting—and the four-column aluminun alloy frame gives it a weight capacity that actually holds up, which is better than some steel carts I’ve seen that flex under pressure.

We run HPLC on the ABS plastic for impact resistance every 500 units or so, and the batch consistency is tight enough that you won’t see color variation between orders; the CE cert covers the whole assembly, not just the frame, so you’re covered on the electrical bits like the infusion rack mounts.

2 of the 4 polyurethane casters have brakes, and what a lot of buyers don’t think to ask is that the brake mechanism is tested for 10,000 actuations—we’ve had a few competitors’ brakes fail after a year, so we made sure ours don’t.

Custom colors are avaliable, and we’ll do OEM branding on the drawer fronts if you need it, but the standard blue is what most hospitals go with because of that it doesn’t show scuffs as badly; the MOQ is 1 unit, so you can order a sample and we’ll send COA with it, no minimum hassle.

Lead time is roughly 20 days or so for a standdard order, but if you need a rush, our company can push it to 10—just confirm stock because we usually have the ABS drawers pre-molded, but the telescoping oxygen bracket and the waste bins are assembled to order, so that can add a week.