Dual Handle Cryolipolysis Slimming Machine for Salon and Home Use with 40KHz Cavitation Technology

We’ve been running BRG80-6S through a full battery of QC before it leaves the floor—HPLC on the cooling fluid batch alongside a 72-hour thermal soak test at -16°C to confirm the dual handles hold steady without drift. So you’re looking at a 400W unit that pulls a consistent vacuum up to 100kPa, and we do a static pressure hold test on each handle at 95kPa for 15 minutes before we call it good.

Every unit ships with a CE cert and a COA for the specific cryo module installed, but we also keep a 5% retest batch form each production run for 30 days in case you want an independent third-party check on fat reduction rates—usually 20-40% per session depending on treatment area. 3. It’s not designed for full body contouring in a single pass though; the 5MHz RF and 40kHz cavitation work best on localized pockets like the flanks or double chin, and the temp range from 5°C down to -16°C means you can dial it in for thicker tissue without freezing the surfce.

What it does is use two cryo heads simultaneously—basically doubling throughput for abdomen and back treatments—and the 63x58x132cm footprint fits most salon rooms without needing a dedicated cooling chiller, though we advise verifying your mains votage for the 400W draw. 5. We OEM and ODM these, so if you need a specific color (silver, white, or blue) or a custom handle interface, that’s factored into the MOQ—about 10 units or so for a first run, but we usually have stock for silver and white.

Anyway, the batch consistency is tight because we test every 20th unit for vacuum decay and RF output stability over 8 cycles, and any failure means that entire batch gets pulled and reworked before shipping (typical lead time is 25 days after order confirmation, but confirm if you need expedited).