Customizable Cryolipolysis Body Contouring Machine with 3 Handle Sizes for Fat Reduction

It really comes down to what size handling you're working with — we've got three applicator heads for this, the large one at 8.5 by 27 by 6.8 cm, a medium at 5.4 by 8.0 by 15.5 cm, and then the small double chin applicator. Controls are chilled precisely between -10°C and 10°C using that water-wind-semiconductor setup, and it's pulling up to 106 kpa of vacuum pressrue.

Basically, this combines three technologies to handle fat and skin: cryolipolysis for targeted fat cell crystallization, 40kHz cavitation for breaking down deeper fat stores, and 5MHz RF for tightening skin during or after cooling phase. It's not gonna hit every lab appliction perfectly, but for salon or clinic use, the touch screen is an 8.0-inch, which is actually a decent size for programming profiles during a session. Teh cooling system tends to maintain consistency across all three handle sizes because the water circuit is integrated — that's something most buyers don't think to check but matters for double chin treatments. You could run a treatment, check the temperature drop, and see it holds steady within about a degree or so. our company can also customize the concentration of cryolipolysis cycles if you're ordering in bulk, but the standerd lab setting is pretty much fine for most.

So for voltage, it runs on either 220V or 110V depending on where you're shiping to, with power draw around 2500W. Net weight is 45 kilos, shipped in a plywood case, so you're not unpacking something fragile. We usually keep handles in stock, but confirm lead time — sometimes the small applicator takes 20 days or so.

The machine's certification is CE, which covers the basic safety standard, and the warranty runs 12 months for the main unit but only 3 months for the handles — they take more wear, so honestly, that's standard. What it does is handle fat reduction treatments pretty reliably for clinics that don't want to swap machines every year. We've found that most buyers go with the large and medium handle sizes for abdomen and thighs, then add the chin piece separately.

Accuracy on the vacuum dial goes to 0-106 kpa, and you'll get a COA with each unit that confirms the cryolipolysis module meets spec within 2-3 degrees — that's tighter than some budget alternatives. Anyway, if you time the cycles right, each treatment drops around 20-25% of the fat layer in the targeted zone.

is the small handle clip isn't as durable as the larger ones, but it's easy enough to swap if it loosens — replace in three months or so. The plate board's sensitive calibration might shift if you drop it, so handle the chin piece like it's delicate.