Account
Inquiry
We're seeing consistent demand from US buyers for these single-phase farm duty motors, especially for pump and gearbox retrofits. They're built with a 1.15 service factor which gives you some headroom for those temporary overloads—just remember it drops to 1.0 at 208V if you're running that voltge.
The TEFC enclosure keeps dust and moisture out, which matters a lot in agricultural settings where you've got grain dust or irrigation spray everywhere. Ball bearings are standard, and manual reset overload protection means you don't have to replace a thermal fuse when it trips. Frame sizes run from 143T to 215T, so it covers most common pump mounts. We ship these with CE and CSA certs, and the import docs for US are usually straightforward—we handle the COA and packing list.
Starting torque is high, which is basically what you need when you're spinning up a loaded gearbox or a centrifugal pump from a dead stop. 100% copper windings in there, not alumnum. Most buyers go with the 1800 RPM 4-pole version for pumps, but the 3600 RPM 2-pole is available if you need higher speed for something like a small compressor.
1/3 HP to 10 HP range, 115/230V or 208-230V options, and it's a rigid base mount. CW/CCW rotation is standdard, so you don't have to worry about shaft direction when wiring it up. IP54 protection class is decent for outdoor use but it's not submersible—keep it sheltered from direct rain if you can. We usually have stock in the 5-10 HP range, but confirm lead time for the smaller sizes, which can run 20 days or so.
One thing we've learned handling these: the manual reset button on the overload protector is a small plastic tab on the side, easy to miss if you're not looking for it. Don't assume it's automatic—you'll have to push it back in after a trip.
