Account
Inquiry
We usually stock about 200 units of these at any time, but lead times can stretch if you need 500 or more — shipping typically takes 2-3 weeks depending on customs.
The main problem with crown preps is inconsistent bonding surfaces, and this unit blasts aluminum oxide at a controlled 1.0mm stream from that 4-hole rotating nozzle, giving you uniform particle distribution across the tooth without guesswork.
You run it at 0.4MPa for most work, though it handles 0.3-0.6MPa if you’re doing different materials; the flow rate is capped at 9g/min so you don’t waste media, and the 360° tip makes access to molars pretty much effortless.
It's not built for heavy composite removal or anything like that — this is strictly surfce prep for bonding, and the autoclavable parts mean you can toss the nozzle and powder tank in sterilization (check with your autoclave's presure rating first though).
Medical-grade stainlss steel body weighs 0.8kg empty, feels balanced in the hand with the ergonomic grip, and the gun-mounted touch switch gives you instant start/stop without reaching for a foot pedal — most buyers go with the 4-hole design over the standard 2-hole because of that uniform spray pattern.
MOQ is 10 units, our company provide COA with each batch, and if you need more than 50 our company can usually ship within 10 days or so — just confirm your preferred particle size for the aluminum oxide when ordering.
Yes, the stainless steel components including the 4-hole rotating nozzle are autoclavable. You can safely remove the nozzle for sterilization, but the entire handpiece body is also designed to withstand autoclave cycles.
We typically have no MOQ for sample orders, so you can order a single DS01 to test in your clinic. For bulk orders, we can discuss volume discounts if you need multiple units.
Yes, the DS01 is CE certified, and we can provide a copy of the certificate with your shipment or upon request. It covers the full unit's compliance with relevant European medical device standards.
The DS01 is optimized for aluminum oxide particles at a flow rate of ≤9 g/min, but you can try other fine powders as long as they match the 1.0mm nozzle diameter. We recommend sticking with aluminum oxide for crown and bridge prep to avoid clogging.
Store the DS01 in a dry, clean environment at room temperature, and keep the powder tank empty to prevent moisture clumping. After each use, flush the nozzle with water briefly and autoclave the components weekly to maintain hygiene.
