Wholesale Animal Surgery Table with Electric Lift, Sink, and Instrument Plate for Research Use

We’d been dealing with a table that just wouldn’t hold position during longer procedures, and the constant manual adjustments were wearing everyone down—so when we found this unit, the electric lift from 760 to 1060 mm was basically a relief.

It’s built form 304 stainlss steel, which handles the regular bleach wipes and rinse-downs without spotting, and the whole thing measures 1400 by 650 mm on the top; the left and right tilt goes to 45° manually, while the front-to-back tilt is automatic to the same angle, which is handy for drainage.

The heating pad runs from 0°C up to 42°C with automatic constant temp control, and in our experience most buyers go with the 35°C setting for recovery work—anything above 40°C is really only used for specific protocols, not something you’d do daily.

Also, movable sink sits in the middle section, so you can pull it out for cleaning without unclamping the whole setup, and the instrument plate and infusion frame are included as standdard; we usually have stock on these, but confirm lead time (typically 2-4 weeks) if you need a rush.

What it does is allow OEM customiztion—they’ll do a different color or add extra tie-down points if you ask, though the binding artifact that comes with it works fine for rats and rabbits, and the MOQ is just one set, so you’re not forced to buy a pallet.

The tilt mechanism has a bit of play after about 500 cycles or so, but for research use that’s pretty much two years of daily tipping—just keep the manual lock engaged when you’re not moving it.