Professional Grade EMS RF Body Slimming Machine with 45000 Muscle Squeezes in 30 Minutes

We've got the Magshape ready for dispatch—68kg of it in an aluminum case, dimensions 78×56×124cm, so make sure your freight forwarder can handle that footprint. It pulls 2600W, which is pretty much the upper end for non-portable units, and the pulse width sits at 300μs with a magnetic wave energy range of 0-7 tesla, so you're getting deep tissue penetration without suface burns if you ramp it slowly.

45000 muscle squeezes in 30 minutes is the headline number, but what it actually does is run that high-intensity focused electromagnetic field through two treatment handles—I-B1 and II-B2—to trigger supramaximal contractions. The frequency splits into F1 at 1-10Hz for sustained tetanus and F2 at 1-100Hz for twitch recruitment, so you can dial in fat oxidation or hypertrophy depending on your protocol. Most buyers go with the Sport Mode for athletes, but Gentle Mode is better for post-op patients or first-timers who can't handle the full squeeze.

It's not suited for spot reduction in areas with metal implants—the 7-tesla field will couple unpredictably, and we don't have data on ferromagnetic interference. The 10.4-inch screen shows real-time impedance (usually 200-600 ohms depending on tissue hydration), and you'll want to check that before each session because dry skin spikes the feedback loop and the unit will trip its overcurrent protection.

CE certified, but we don't have FDA clearance yet (check lead time if that's a dealbreaker). The aluminum case isn't just for transport—it doubles as a Faraday cage during storage, which matters if you're stacking it near other RF equipment because the 2600W output can ghost-write on unshielded controllers. We usually have stock, but confirm lead time for international orders—shiping runs 20 days or so by sea, air freight adds about 40% to the cost.

Treatment modes are Sport, Gentle, and Profesional—the difference is mostly in ramp-up curve and hold time at peak contraction. Professional mode holds at 100% duty cycle for 4 seconds, which is brutal on the power supply but gets results faster. You'll want a dedicated 20A circuit for this thing; plugging it into a standard 15A outlet with other gear running will trip breakers within 5 minutes at full power.