Account
Inquiry
You've got a wire that needs, then a connector that needs crimping, and switching between two tools in the middle of a job—this plier does both in one pass, which saves time on ladders or up on scaffolding.
The box joint keeps the jaws aligned under pressrue, so you're not fighting slop when you crimp a terminal, and the arched shaft lets you get a solid grip without your hand cramping up after the 50th use.
It's a 100mm plier overall but the blade thickness is 1.4 inches, which sounds odd until you realize that's the edge's actual bite—most buyers go with orange-handled version for visibility on a messy worksite, and the thumb knob lets you swap blades without hunting for a hex key.
Weight is 0.03kg, pretty much nothing, and the package is 105×35×45mm—so you can toss a dozen in a small bin and ship them anywhere without worrying about dimensional weight penalties.
We usually have stock on these, but bulk orders of 500 units or so need a lead time of roughly 3 weeks (check with us first), and the MOQ is 50 pieces if you're testing teh water.
One thing we get asked a lot: it's fine for copper wire and small steel cable up to about 3mm, but it's not meant for hardened steel or thick rebar—that's where the jaw just won't have the, and you'll damage the edge.
The MOQ is typically 100 units per order, but we can discuss smaller quantities if you're testing the market.
Standard lead time is 15-20 business days after order confirmation, depending on your location and shipping method.
Yes, we can provide a material certificate for the stainless steel and a performance test report upon request.
We can adjust blade thickness within a range, but 1.4 inches is our standard. Customization requires a minimum order of 500 units.
Each unit is packed in a box measuring 105×35×45mm, and bulk orders are shipped in cartons to prevent damage during transit.
