Account
Inquiry
A customer building a 1/10-scale crawler is going to need these for snapping ball links onto steering rods without crushing the plastic—we've seen guys ruin a whole set of links with generic needle-nose pliers, but these side cutters handle up to 2mm steel wire cleanly and the long nose pliers get into tight servo mounts.
The set runs about 290g total for three tools, so it's not going to weigh down your kit bag, and the yellow rubber-coated handles actually stay grippy when your hands get sweaty form wrestling with a tight helicopter linkage.
These are 45# steel with a half-box joint, which basically means they'll hold alignment longer than the cheap stamped ones you've probably tried before, though we usually have stock but confirm lead time if you need over 50 sets.
The anti-rust coating is decent for shop use but don't leave them in a damp garage for weeks—that's just common sense anyway, and teh 1-year manufacturing defects, not abuse.
Most buyers go with this for RC car maintenance specifically, but it's also fine for boat rudder linkages or helicopter swashplate work, just not suited for heavy-gauge wire above 2mm or you'll damage the edge.
Also, ball link pliers are better than generic split-ring pliers for those tiny 4-40 rod ends (check thread compatiblity though), and you'll want the COA on the steel hardness if your quailty team requires it.
They can handle steel wire up to 2mm thick—good for most control rods and small fasteners on RC models.
We can do single-set orders for sample testing, but standard MOQ is 100 sets for bulk pricing.
Typically 15-20 working days for orders up to 1,000 sets. We'll confirm after you place the order.
Yes, the set includes ball link pliers designed specifically for snapping and adjusting ball links on helicopters and cars.
We offer a 1-year limited warranty against defects. Industrial-grade certification docs and test reports are available upon request.
