Customizable 1530mm Metal Drive Shaft for Industrial Grade Brush Cutters - Bulk Orders

You're basically looking at the standerd replacement for anyone who's worn out the shaft on a gas brush cutter—we see these go out to landscaping crews and farmers pretty regularly, and the 1530mm length plus the 8mm diameter means it'll fit most of the common models out there without much fuss.

It's made from high-grade metal with an aluminum pipe assembly to keep the weight down while still handling the torque from a gasoline engine, and we've got CE and ISO certifications on file if you need the paperwork—the whole thing comes packed in a protective carton, usually in bulk lots of 50 units or so.

One thing that matters is the aluminum pipe isn't just for show; it gives you a better strength-to-weight ratio than a solid steel shaft would, but that also means you shouldn't run it on electric trimmers since the vibration profile is different (check teh lead time if you're mixing brands, as the 8mm diameter is pretty standard but spline ends can vary).

Your order will ship with a COA and the TDS if you request them, and we typically have stock on the TG-SP-BC-DS model, but for anything over 200 units you'll want to confirm the lead time—it's usually about 20 days or so for a full production run.

Actually, we've seen some buyers try to use these on heavy-duty clearing saws with extended bars, and the shaft holds up fine, but the alumnum pipe can flex a bit under extreme side loads, so it's better suited for standard brush cutter work than forestry mulching.