Account
Inquiry
We've been running these roll coaters for years now, and the JYJ model handles the full range of hot melt adhesives you'd want for fabric waterproofing—PA, PES, EVA, PU, TPU—without needing a separate machine for each. What it does is let you dial in form 150 to 250 degrees and handle viscosities up to 150,000 cps, so it's not just for thin coatings. Most buyers go with this for continuous membrane roll production at 50 to 500 meters per minute, and it's better than a standard glue spreader for keeping the layer even.
But it's not ideal for low-melt materials below that range, and you'll want to confirm your adhesive's flow characteristics before committing—we usually have stock, but confirm lead time if you're in a rush. The working temperature is pretty much locked in for hot melts, so if you're running solvent-based or water-based coatings, this isn't your machine.
You'll get a 12-month warranty on the unit, and it ships in a wooden case with flexible film—CE marked, so customs clearance is typically straightforward. We've seen these run for years in production lines without major issues, and one thing I'd mention is that the coating roller alignment is tighter than most competitors, which cuts down on waste during startup.
The drive is electric and fully automatic, so you're not manually adjusting speed or tension once it's set—the control panel handles that. For documentation, we provide a COA with each machine and can supply a TDS for the adhesives you plan to use, though I'd recommend asking for the HPLC data if your application requires tight purity specs.
Anyway, the color is blue, and the packging matrial is wood, but that's just standard—what matters is that machine is built for continuous runs, not just small batches. Lead time is usually 20 days or so, give or take depending on the order volume.
Typical lead time is around 30-45 days after order confirmation, depending on the customization level. For just a color change or small tweak to the roller width, we can usually keep it on the shorter side.
Yes, the machine is built to CE standards, and we include the CE certificate with shipment. We can also supply material test reports for the rollers if needed.
Absolutely, the machine is designed to work across the full 3000-150000cps range. For low-viscosity PA or TPU, we recommend adjusting the roll gap and temperature to avoid dripping.
It ships in a wooden case with flexible film wrap, so it stays dry and protected. Store it in a clean, dry area between 5-40°C, and keep the film intact until you're ready to set it up.
Yes, we can adjust the roller width and speed settings to match your fabric specs or line speed. Just share your fabric width and line details, and we’ll confirm the modifications.
