Account
Inquiry
When you’re running high-volume electrical or automotive assembly and every cut needs to be clean on up to 6mm hard wire, these clippers handle the load without wearing out mid-shift — we see them used daily in heavy cable prep and tie-rod cuts where cheaper tools just slip off after a few weeks.
Basically, they’re forged from high carbon steel with a chrome plated suface that sheds rust and grime well enough for outdoor construction sites, and the box joint keeps teh jaws aligned even after thousands of snips on 4mm steel wire or tougher stainlss runs.
Three sizes come through our line — 6, 7, and 8 inches — with net weights between 16 and 23 ounces or so, so the 6-inch variant is smart for tight junction boxes while the 8-inch gives you that extra lever advantage on 6mm or 5/16-inch hard steel.
You’ll get them packed in standerd export cartons at a thousand-piece MOQ, and we usually hold stock for a 20-day lead time unless your order spikes past 50,000 units (check availability if you need them fast for a big job).
They’re not built for fine electronics work like snipping PCB leads or thin copper — the heavy-duty and ergonomic non-slip handle are really aimed at guys turning wrenches in auto repair or pulling wire all day, where hand fatigue actually matters by hour four of a panel install.
Each tool goes through a basic quality check, and our company can attach a COA showing hardness typically runs around HRC 48-52 on the edge, which is better than what most import punches deliver for this price point but still leaves some room for your shop to re-hone if you’re hardened steel every shift.
