Premium Quality 150mm Hand Tools Set Including Long Nose and Side Cutting Pliers

The hardness differential is what actually caught my attention here — 45 HRc on the main body and then 55-65 HRc specifically on the edges, which means the jaws won't crack under stress but the blades still bite cleanly through wire without dulling after a few dozen cuts.

Basically, you're getting three 6-inch pliers in one blister pack: a combination cutter/crimper, a side cutter, and a long nose with tapered jaws for those tight spots behind panels or inside junction boxes where you'd normally have to contort your wrist.

We've already run these through a couple of test batches for other buyers doing electrical harness work, and the chrome plating actually holds up better than cheaper satin finish tools we've handled — less flaking around teh pivot pin after about 200 cycles or so.

The MOQ is 500 sets, which is pretty standard for OEM branded tools from this suplier, and they'll do either black or red handles on the grips (usually black unless you specify otherwise).

One thing that's worth mentioning even though it's not on the sheet: the crimping zone on the combination pliers isn't really designed for insulated terminals — it's better suited for bare wire splices and non-insulated lugs, so if your guys need to crimp heat-shrink connectors, you'll want to get a dedicated ratcheting crimper seperately.

Lead time from order to ship is typically 25 days or so, and they'll provide COA with hardness readings for each lot if you ask — we usually just include that in the PO notes.