255*1.5*40T*25.4 Professional Grade Saw Blades for Tough Weed Cutting

We run every batch through a full set of dimensional checks before it gets released—diameter tolerance within +/- 0.2mm and thickness held to 1.5mm +/- 0.03mm across the entire run, which keeps vibration consistent when you're pushing through heavy brush or dense shrubs, and we back that up with a retest policy if your incoming QC flags anything outside those limits.

40T on a 255mm blade is a pretty specific sweet spot for this application, and the carbide tips are brazed with a controlled preheat cycle we've dialed in over last few years; it's not uncommon for buyers to request a sample run of 50 units or so to verify the edge retention on their particualr material mix before committing to a full MOQ.

The 25.4mm arbor is standard for most commercial trimmers and brush cutters, but what you don't always see on a spec sheet is the concentricity check we do after laser marking—surfce treatment doesn't affect balance if the heating is even, and we've seen some shops skip that step, so we always include it in our internal test protocol along with a hardness spot check on every fifth blade from the line.

Actually, we usually have stock on the FWGR10026 profile, but customiaztion—colors or custom laser markings for your brand—adds about 20 days or so to lead time, and the retest policy applies the same way whether it's a standard or OEM run, so you're covered either way.